[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[avrdude-dev] Support for at-isp v1.1?
From: |
Brammeleman |
Subject: |
[avrdude-dev] Support for at-isp v1.1? |
Date: |
Tue, 11 Apr 2006 11:35:34 +0200 |
Hi,
Recently I bought a atmega8 development board from futurlec/mrt. This
board has it's own, yet another idea how the isp connector and
(parallel) programming cable (labeled AT-ISP V1.1) looks like. There's
also a windows software supplied to program the uC.
All signal lines between the isp connector and atmega8 (reset, sck,
mosi, miso) are inverted with a 74ls04.
Since all IC components are installed in a socket, I was able to
bypass the inverters, by inserting wires in the ic socket of the
74ls04 (creating a pin compatible 'passive non-inverting device' ;-)).
With the following added to /etc/avrdude.conf, I was able to program
the atmega8:
programmer
id = "atisp";
desc = "AT-ISP V1.1 programming cable for AVR-SDK1 from
micro-research.co.th";
type = par;
reset = 6;
sck = 8;
mosi = 7;
miso = 10;
;
My questions are:
- Is anyone using this board successfully with avrdude?
- Would it be possible let avrdude invert the programming signals, so
that a board like this would be directly supported?
The avrdude.conf file might then, for example look like:
programmer
id = "atisp";
desc = "AT-ISP V1.1 programming cable for AVR-SDK1 from
micro-research.co.th";
type = par;
reset = _6;
sck = _8;
mosi = _7;
miso = _10;
;
Using some character (_) to invert a pin.
Thanks,
Bram
- [avrdude-dev] Support for at-isp v1.1?,
Brammeleman <=