Re: [Discuss-gnuradio] PC requirements for DVB-S2 processing at a high bandwidth

[Ron Economos]

The processing requirement for DVB-S2 are significant, especially the 
receiver. Since you're using an X-series USRP, I'll guess you're 
interested in satellite downlinks which can be 30 to 50 Msyms/s.

Basically, the requirement would be the most powerful system you can 
afford. Something with an Intel i9 or Xeon Gold/Platinum series processor.

Even then, real-time processing for the receiver will be limited unless 
you use an FPGA or GPU for the LDPC decoding.

The good news is that I've ported an SIMD optimized LDPC decoder to GNU 
Radio.

https://github.com/drmpeg/gr-dvbs2rx

Which is ported from:

https://github.com/xdsopl/LDPC

However, it's still not capable of satellite bitrates.

Ron

On 1/31/19 10:33, Maria Jesus Cañavate Sanchez wrote:
> Hi there!
>
> My name is Maria and I would like to make a question regarding the 
> kind of PC characteristics which would be required to be able to 
> process the signal in real-time (on the PC) when using the maximum 
> bandwidth available on the USRP X-series.
>
> The scenario would be the following one: we would like to use GNU 
> radio to send and receive DVB-S2 signals. Hence, the PC will do all 
> the processing to check the BER, constellation, EVM, etc. Do you think 
> it is possible to use a PC (with SSD drive and some suggested 
> requirements) which could do the processing in real time or the only 
> way to achieve that bandwidth in real time would be using the FPGA of 
> the USRP? If the second case, then I guess we will do the processing 
> off-line =)
>
> Thank you very much in advance!
>
> Best regards,
>
> Maria Jesus
>
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden
> https://lists.gnu.org/mailman/listinfo/discuss-gnuradio