Re: [fluid-dev] Telnet to fluidsynth

[Ben Gonzales]

Apologies... all fixed. There was a symlink that wasn't right.

Thanks for your help.

Ben

On 02/06/16 12:51, Ben Gonzales wrote:

Well, I removed fluidsynth with

sudo apt-get remove fluidsynth

did the git thing:

git clone git://git.code.sf.net/p/fluidsynth/code-git fluidsynth

cmade it as per the instructions, and after getting rid of the old fluidsynth library, it works, but I still have the same problem. Telnet fails.

The git version says its 1.1.6 . Is that right?

Ben

On 02/06/16 07:54, Ben Gonzales wrote:

Thanks for that.

Do I need to remove the installed fluidsynth before compiling from git?

Ben

On 01/06/16 21:13, Marcus Weseloh wrote:

Hi Ben,

this is a known problem:

http://lists.nongnu.org/archive/html/fluid-dev/2015-01/msg00008.html

I'm not sure if the fix has been included in a release yet, but getting the latest sources from git and recompiling should fix your problem.

All the best,

   Marcus

2016-06-01 12:49 GMT+02:00 Ben Gonzales <address@hidden>:

I'm running 1.1.6-2 on my RPi2 (Debian), and I can't telnet to a running fluidsynth. It connects (port 9800), then the connection is immediately closed by the host.

Any ideas?

Ben

_______________________________________________
fluid-dev mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/fluid-dev

_______________________________________________
fluid-dev mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/fluid-dev

_______________________________________________
fluid-dev mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/fluid-dev

_______________________________________________
fluid-dev mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/fluid-dev