[Gnump3d-users] Re: still can't get gnump3d to install on nslu2

[Cle Crape]

Worked like a charm.  Thanks for the help.

On 9/12/06, Onur Akgün <address@hidden> wrote:

Hi,

At the time when I was trying to install gnump3d, I've also struggled
with this problem, which is actually not related with gnump3d. Problem
is you don't have necessary tools to make/make install; yet :o)

As far as I remember, you should install coreutils package (ipkg
install coreutils). After that,  just try (make install) again.

Hope it helps,

Onur

>
> ---------- Forwarded message ----------
> From: "Cle Crape" <address@hidden>
> To: address@hidden
> Date: Mon, 11 Sep 2006 15:43:24 -0500
> Subject: [Gnump3d-users] still can't get gnump3d to install on nslu2
> I followed the wiki on
> http://www.nslu2-linux.org/wiki/Unslung/GettingGnump3dInstalled
> and I looked at the thread by Ian Barton and Steve Kemp but I still can't
> gnump3d to compile.  Any suggestions would be appreciated.
>
> Here's a bit of system info:
>
> Perl info:
> -bash-3.1# perl -e 'for my $i ( @INC ) { print $i . "\n"; }';
>  /opt/lib/perl5/5.8.8/armv5b-linux
> /opt/lib/perl5/5.8.8
> /opt/lib/perl5/site_perl/5.8.8/armv5b-linux
> /opt/lib/perl5/site_perl/5.8.8
> /opt/lib/perl5/site_perl
>
> I modified the Makefile like so:
> LIBDIR      = /opt/lib/perl5/site_perl
>
> Then when I run "make install" I get this:
> -bash-3.1# make install
>  install -d /etc/gnump3d
> make: install: Command not found
>  make: *** [install] Error 127
>
>
>
> _______________________________________________
> Gnump3d-users mailing list
> address@hidden
> http://lists.gnu.org/mailman/listinfo/gnump3d-users
>
>
>