[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: LYNX-DEV ver
From: |
T.E.Dickey |
Subject: |
Re: LYNX-DEV ver |
Date: |
Tue, 8 Apr 1997 19:05:28 -0400 (EDT) |
> address@hidden (Robert Wilkens) wrote:
> >FYI: The release I'm using is 2.7.1.
>
> Then it's puzzling why that ifdefing isn't getting NGROUPS
> defined. In the worst case, it should end up defined arbitrarily
> to 32. You can try adding -DNGROUPS=# in your SITE_LYDEFS for the
> top-level Makefile, where # is the value in your limits.h.
>
> Perhaps Tom Dickey, who's been developing an autoconf for
> Lynx, has some thoughts on the matter.
Not really - I did a grep to see if there was any place that NGROUPS would
be used out of order, found none (though I see that solaris2 uses a value
of 16, so I made a note to construct a test for this).
-- but that's looking at the development version (I'll check on 2.7.1).
--
Thomas E. Dickey
address@hidden
http://www.clark.net/pub/dickey
;
; To UNSUBSCRIBE: Send a mail message to address@hidden
; with "unsubscribe lynx-dev" (without the
; quotation marks) on a line by itself.
;
- LYNX-DEV ver, Robert Wilkens, 1997/04/08
- Re: LYNX-DEV ver, Foteos Macrides, 1997/04/08
- Re: LYNX-DEV ver,
T.E.Dickey <=
- LYNX-DEV Table toggle, Julian Rodriguez, 1997/04/08
- Re: LYNX-DEV Table toggle, Mike Brown, 1997/04/09
- Re: LYNX-DEV Table toggle, Al Gilman, 1997/04/09
- Re: LYNX-DEV Table toggle, Larry W. Virden, x2487, 1997/04/09
- Re: LYNX-DEV Table toggle, Julian Rodriguez, 1997/04/09
- Re: LYNX-DEV Table toggle, Alan Cox, 1997/04/10
- Re: LYNX-DEV Table toggle, Larry W. Virden, x2487, 1997/04/10
- Re: LYNX-DEV Table toggle, tz, 1997/04/10
- Re: LYNX-DEV Table toggle, Michael Ritzert, 1997/04/11
- Re: LYNX-DEV Table toggle, tz, 1997/04/14