[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: LYNX-DEV LYNX reads "off" from .lynxrc set_cursor=on
From: |
Greg Marr |
Subject: |
Re: LYNX-DEV LYNX reads "off" from .lynxrc set_cursor=on |
Date: |
Thu, 19 Feb 1998 09:51:27 -0500 |
>I have show_cursor=on in my .lynxrc file, as you
>can see down below.
>
>I also explicitly set -show_cursor on the command-line:
[...]
>
> 192 # one which does not distingish the current link based on highlighting
> 193 # or color. A value of "on" will set positioning to the left as the
> 194 # default while a value of "off" will set 'hiding' of the cursor.
> 195 # The default can be overridden via the -show_cursor command line
toggle.
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
> 196 show_cursor=on
It's turned on in your .lynxrc, but then your command line switch is
turning it off again.
--
Greg Marr
address@hidden
"We thought you were dead."
"I was, but I'm better now." - Sheridan, "The Summoning"
Re: LYNX-DEV LYNX reads "off" from .lynxrc set_cursor=on, Al Gilman, 1998/02/19
Re: LYNX-DEV LYNX reads "off" from .lynxrc set_cursor=on, David Combs, 1998/02/19
Re: LYNX-DEV LYNX reads "off" from .lynxrc set_cursor=on, Nelson Henry Eric, 1998/02/19