[Lynx-dev] help me

[oleg ershov]

Hello, 
I have a basic question about LynxOS.
I have just installed LynxOS-178  2.1.0 on x86.
My board is CM-F82 CompuLab. I am using LynxOS-178  2.1.0 .I use U-boot 1.1.3  
as my bootloader
I have tried booting both the kdi files. I have target platform - PowerPC; 
Board: CM-F82 CompuLab, busfreq 100 MHz; processor MPC8272 Freescale. 
FLASH=4MB; DRAM=128MB
How to boot  .kdi image files?
I have two files: los178.ram.img and arinc-demo.kdi for LynxOS-178(Company 
LynuxWorks).
It well(OK) works for los178.ram.img.
It not well works arinc-demo.kdi.
I try to arinc-demo.kdi and get the following message:
"NIP: 00005020 XER: 20000000 LR: 07FCE7F4 REGS: 07bbdcc0 TRAP: 0700 DAR: 
00000000
MSR: 0008b002 EE: 1 PR: 0 FP: 1 ME: 1 IR/DR: 00
GPR00: 07FCE7E4 07BBDDB0 800B3894 00000001 07BC0BF4 00000010 FFFFFFFE 00000003 
GPR08: 00000041 F0000091 FFFFFFFF F0000088 00000000 7B7D6FE4 07FFD000 00000000 
GPR16: 00000000 00000000 00000000 00000000 0000B002 07BC0C10 07BC0B40 00000000 
GPR24: 07BBDE50 00000000 00000000 00000002 00005020 07BBDF6C 07FFD768 07BC0BF4 
Call backtrace: Program Check Exception"
For los178.ram.img :
setenv serverip 192.168.151.119
tftp 0x4000 los178.ram.img
go 0x5020 
OK.
Why error arinc-demo.kdi?
The address 0x4000 for tftp 0x4000 arinc-demo.kdi correct?
The Offset 0x5020 for go correct?
What could I be doing wrong?
Please let me know the solution of this problem.
Any ideas?
Any pointers do such a beast?  
Thank you in advance.
Thanks a lot.
Best regards,
Oleg Ershov.

HyperTerm_arinc-demo kdi.txt
Description: Text document

config.tbl
Description: Binary data

config.out
Description: Binary data

HyperTerm_Los178 ram img.txt
Description: Text document