[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: syntax errors with “check program” fo r custom bash script
From: |
Jan-Henrik Haukeland |
Subject: |
Re: syntax errors with “check program” fo r custom bash script |
Date: |
Sat, 15 Jun 2013 03:30:46 +0200 |
Hm, I'm not able to reproduce this, but here are a few pointers
1. check program myscript with path "/usr/bash /etc/monit.d/script_to_run.sh"
This is currently not allowed, the path must only contain the full path to your
script without any arguments.
2. Instead of doing Monit reload, do a Monit quit and start again.
3. Make sure that the user running Monit has permission to execute the script
On Jun 15, 2013, at 2:32 AM, s contini <address@hidden> wrote:
> yep, execute bit set too.
>
> From: Jan-Henrik Haukeland <address@hidden>
> To: This is the general mailing list for monit <address@hidden>
> Sent: Friday, June 14, 2013 3:30 PM
> Subject: Re: syntax errors with “check program” for custom bash script
>
>
> On Jun 15, 2013, at 12:25 AM, Jan-Henrik Haukeland <address@hidden> wrote:
>
> > check program was introduced in Monit 5.5
>
> My bad, it was introduced in 5.3, so 5.4 is fine. Check that you have the
> execute bit set on the script. I.e. chmod 755 /etc/monit.d/script_to_run.sh
> --
> To unsubscribe:
> https://lists.nongnu.org/mailman/listinfo/monit-general
>
>
> --
> To unsubscribe:
> https://lists.nongnu.org/mailman/listinfo/monit-general