[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Qemu-ppc] [PATCH 1/3] VFIO: Clear stale MSIx table during EEH reset
From: |
Alex Williamson |
Subject: |
Re: [Qemu-ppc] [PATCH 1/3] VFIO: Clear stale MSIx table during EEH reset |
Date: |
Fri, 13 Mar 2015 15:33:50 -0600 |
On Wed, 2015-03-11 at 17:11 +1100, Gavin Shan wrote:
> The PCI device MSIx table is cleaned out in hardware after EEH PE
> reset. However, we still hold the stale MSIx entries in QEMU, which
> should be cleared accordingly. Otherwise, we will run into another
> (recursive) EEH error and the PCI devices contained in the PE have
> to be offlined exceptionally.
>
> The patch clears stale MSIx table before EEH PE reset so that MSIx
> table could be restored properly after EEH PE reset.
>
> Signed-off-by: Gavin Shan <address@hidden>
> ---
> hw/vfio/common.c | 6 +++++-
> hw/vfio/pci.c | 39 +++++++++++++++++++++++++++++++++++++++
> include/hw/vfio/vfio.h | 3 ++-
> 3 files changed, 46 insertions(+), 2 deletions(-)
>
> diff --git a/hw/vfio/common.c b/hw/vfio/common.c
> index 148eb53..e3833f4 100644
> --- a/hw/vfio/common.c
> +++ b/hw/vfio/common.c
> @@ -949,8 +949,12 @@ int vfio_container_ioctl(AddressSpace *as, int32_t
> groupid,
> switch (req) {
> case VFIO_CHECK_EXTENSION:
> case VFIO_IOMMU_SPAPR_TCE_GET_INFO:
> - case VFIO_EEH_PE_OP:
> break;
> + case VFIO_EEH_PE_OP:
> + if (!vfio_container_eeh_event(as, groupid, param)) {
> + break;
> + }
> + /* fallthru */
> default:
> /* Return an error on unknown requests */
> error_report("vfio: unsupported ioctl %X", req);
> diff --git a/hw/vfio/pci.c b/hw/vfio/pci.c
> index 6b80539..8c4a8cb 100644
> --- a/hw/vfio/pci.c
> +++ b/hw/vfio/pci.c
> @@ -3319,6 +3319,45 @@ static void vfio_unregister_req_notifier(VFIOPCIDevice
> *vdev)
> vdev->req_enabled = false;
> }
>
> +int vfio_container_eeh_event(AddressSpace *as, int32_t groupid,
> + struct vfio_eeh_pe_op *op)
Called by common, but lives in pci. This would need a stub if QEMU is
built without CONFIG_PCI. Thanks,
Alex
> +{
> + VFIOGroup *group;
> + VFIODevice *vbasedev;
> + VFIOPCIDevice *vdev;
> +
> + group = vfio_get_group(groupid, as);
> + if (!group) {
> + vfio_put_group(group);
> + error_report("vfio: group %d not found\n", groupid);
> + return -1;
> + }
> +
> + switch (op->op) {
> + case VFIO_EEH_PE_RESET_HOT:
> + case VFIO_EEH_PE_RESET_FUNDAMENTAL:
> + /*
> + * The MSIx table will be cleaned out by reset. We need
> + * disable it so that it can be reenabled properly. Also,
> + * the cached MSIx table should be cleared as it's not
> + * reflecting the contents in hardware.
> + */
> + QLIST_FOREACH(vbasedev, &group->device_list, next) {
> + vdev = container_of(vbasedev, VFIOPCIDevice, vbasedev);
> + if (msix_enabled(&vdev->pdev)) {
> + vfio_disable_msix(vdev);
> + }
> +
> + msix_reset(&vdev->pdev);
> + }
> +
> + break;
> + }
> +
> + vfio_put_group(group);
> + return 0;
> +}
> +
> static int vfio_initfn(PCIDevice *pdev)
> {
> VFIOPCIDevice *vdev = DO_UPCAST(VFIOPCIDevice, pdev, pdev);
> diff --git a/include/hw/vfio/vfio.h b/include/hw/vfio/vfio.h
> index 0b26cd8..99528a3 100644
> --- a/include/hw/vfio/vfio.h
> +++ b/include/hw/vfio/vfio.h
> @@ -5,5 +5,6 @@
>
> extern int vfio_container_ioctl(AddressSpace *as, int32_t groupid,
> int req, void *param);
> -
> +extern int vfio_container_eeh_event(AddressSpace *as, int32_t groupid,
> + struct vfio_eeh_pe_op *op);
> #endif