[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Rule-list] successful slinky v0.2.3 install
From: |
Michael Fratoni |
Subject: |
Re: [Rule-list] successful slinky v0.2.3 install |
Date: |
Fri, 10 May 2002 21:31:42 -0400 |
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
On Friday 10 May 2002 09:38 pm, address@hidden wrote:
> After I couldn't ping I switched to the other drive and pinged fine,
> testing the hub and cables. A day later I powered back up and
> pinged. Then I changed back to the slinky install drive and pinged out
> fine.
You couldn't ping by ip address, or hostname? Are you getting a hostname
lookup failure, or no route to host?
> So I reinstalled from the slinky floppies. After kudzu ran and I
> entered my ip info i still couldn't ping out. I reset and I still
> couldn't ping out. I did a power down and restart and I pinged out
> fine.
You got me. :) I did add a few files to /etc to make life easier for
those doing a network install. I should add a check to clean them up if
not needed, they may have something to do with this problem. Have a look
at /etc/hosts /etc/host.conf, and /etc/resolv.conf
Also, could you check for and provide a list of rpmsave and rpmnew files
on the system for me?
- --
- -Michael
pgp key: http://www.tuxfan.homeip.net:8080/gpgkey.txt
Red Hat Linux 7.2 in 8M of RAM: http://www.rule-project.org/
- --
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.0.6 (GNU/Linux)
Comment: For info see http://www.gnupg.org
iEYEARECAAYFAjzcdH4ACgkQn/07WoAb/SsvmQCgoiC7c+6oheqwF76g36wnEj8g
wJIAoKvnX0KiERjJeYYKo6ra8+X+/qGU
=bqXx
-----END PGP SIGNATURE-----