[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Rule-list] Re: no ppp support in install kernel?
From: |
Raymundo Baquirin |
Subject: |
[Rule-list] Re: no ppp support in install kernel? |
Date: |
Sun, 19 May 2002 00:53:33 +0800 |
Hi, Michael,
On Friday 10 May 2002 00:00, you wrote:
> Grab the slip.o and slhc.o modules from
> http://www.tuxfan.homeip.net/rule/slinky/MODULES/kernel/drivers/net/
> Put them on a floppy (disk2 should be fine) and load them before using
> slattach. (slhc should be loaded first)
> I just got it working here using the slinky disks.
I'm finally reunited with the serial cable and tried the setup with slattach
again. But no joy. I can't ping either machine from the other.
What I did:
On my desktop machine:
slattach -p slip -s 19200 /dev/ttyS1 &
ifconfig sl0 192.168.1.1 pointopoint 192.168.1.2 up
route add -host 192.168.1.2 sl0
On the laptop:
mkdir /mnt/win #make mount point
mount -t vfat /dev/hda1 /mnt/win #mount win partition
cd /mnt/win/rule/slinky/2.3 #where needed files are
insmod slhc.o # load kernel module
insmod slip.o # -do-
cd /dev
mknod -m 666 ttyS0 c 4 64 # make device for 1st serial port
cd /mnt/win/rule/slinky/2.3 #where slattach is
./slattach -p slip -s 19200 /dev/ttyS0 &
ifconfig sl0 192.168.1.2 pointopoint 192.168.1.1 up
route add -host 192.168.1.1 sl0
route add default sl0
I did notice in the slinky boot messages that the serial ports are called
ttyS00 and ttyS01. I tried making a ttyS00 device instead of ttyS0 but still
got no ping.