[RULE] Problem starting X (GUI)

[Ingo Lantschner]

Hi,
I have a testingmachine with the following graphicscard:
        GRAPHIC CARD MODEL :S3 86c765 Trio 64V+
        GRAPHIC CARD RAM :2048 kB
        GRAPHIC CARD BUS : PCI
        
Installing Rule with Slinky 0.3.8 and RH 8.0 works fine up to the
commandline.  Starting X (startx) does not work. After consulting some
documentation I found out that I must start the xfs fontserver first.
This did even not help me.  Still no GUI.

Also there is not much difference between Gnome and KDE - I tried both.

As a last try, I put the path to the fonts directly in the XFConfig-File
(as suggested on the rule-mailinglist) - the problem persists - no GUI.

Following the Configfile and the logfiles. May be someone can help.

Thanks Ingo.

----


XFree86.0.log (standard Rule-Install, no changes in XF86Config):

--- snip ---
...
(**) s3(0): DPMS enabled
Symbol xf86InterpretEDID from module /usr/X11R6/lib/modules/libvbe.a is 
unresolved!
(II) Initializing built-in extension MIT-SHM
...
(II) XINPUT: Adding extended input device "Mouse0" (type: MOUSE)
Could not init font path element unix/:7100, removing from list!

Fatal server error:
could not open default font 'fixed'
...
--- snap ---

attached XF86Config: changed the path to fontfiles
attached XFree86.0.log: resulting logfile






-------------------------------------------------------------------
Ingo Lantschner

        Verein zur Unterstuetzung von Menschen
        Marchettigasse 5/11, A-1060 Wien
        Tel (+43-1) 595 5766
        Fax (+43-1) 532 4041
        http://www.vum.at/
-------------------------------------------------------------------

XFree86.0.log
Description: Binary data

XF86Config
Description: Binary data