Re: [avrdude-dev] [bug #40748] linuxgpio doesn't work on Raspberry PI rev. 2.

[René Liebscher]

On 30.11.2013 11:57, Radoslav Kolev wrote:
> On Sat, Nov 30, 2013 at 10:15 AM, Joakim Lubeck <address@hidden> wrote:
> > On Fri, November 29, 2013 11:42 pm, René Liebscher wrote:
> > Now I don't know the details here, but should there be only || in that if
> > statement? I tested with
> No, this check is a kludge, to allow 0 based pin numbers, before René
> submitted the proper changes for that. The best solution would be to
> convert linuxgpio programmer to use this new infrastructure. I haven't
> had time to do this unfortunately.
This should be now a little bit easier to realize as I changed the 
interface of setpin, getpin, and highpulsepin, so you have the choice to 
use the new pindefs here.
Linuxgpio needs to be tested that my changes did not break anything. 
(The same is true for serial bitbanging devices. Parport and 
buspirate_bb is already tested by me.)


Kind regards,

René