Re: Doubt about plotting on MAC OS X Catalina

[Antonio Juan]

Thanks; I need to completely read the GNU-APL DOC, sorry about that

You are right the problem is with the libxcb.

⎕plot 1 2 3 4 5

SYNTAX ERROR+

      ⎕PLOT 1 2 3 4 5

      ^

      )MORE

⎕PLOT is not available because either no libxcb library was found on this

system when GNU APL was compiled, or because it was disabled in ./configure.

Exist a tutorials for building gnu-apl in OSX

Thanks for your time

Toni 

El 26 nov 2019, a las 17:27, Dr. Jürgen Sauermann <address@hidden> escribió:

Hi Toni,

the + character after SYNTAX ERROR (or any other APL error) indicates that there
is more information available regarding that error. The additional information
can be displayed with command )MORE.

I suspect that in this particular case libraries needed for plotting (essentially libX11.so,
libxcb.so, and libX11-xcb.so) were missing on the platform where GNU APL was compiled
(i.e. your own machine if you compiled from source or the build machine of a package if
you installed a binary package).

For ⎕PLOT to work, you may need to compile the interpreter from source with the required
X libraries installed beforehand.

Best Regards,
Jürgen Sauermann

On 11/26/19 2:27 PM, Antonio Juan wrote:

Thanks for this awesome software. I have installed gnu plot 1.8 from brew package. It works well, and good integration with emacs. So it is a good environment for learning APL.

The only think is that when I try to plot I always get the following error:

       ⎕PLOT 0 1 ¯1 2 ¯2 3 ¯3
SYNTAX ERROR+
      ⎕PLOT 0 1 ¯1 2 ¯2 3 ¯3
      ^

I do not see anywhere, if is needed to load a workspace, or the needed for some environment configuration during installation. So really I do not know how to proceed.

Thanks for your time

Toni