[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Bug-gnubg] bug: reedit cube position
From: |
Jon Kinsey |
Subject: |
Re: [Bug-gnubg] bug: reedit cube position |
Date: |
Thu, 09 Oct 2003 11:53:10 +0100 |
At 11:03 09/10/2003, Achim Mueller wrote:
I just tried to edit a position again, where I set cube at the wrong
value. There seems to be no possibility in the gui to reset a cube
from owner back to middle or change the value again.
Also a commandline "set cube value/owner" shows no effect.
Hi Achim,
Can you give some more detail, I just did the following with the 3d/panel
build (2d board):
1 start 5pt match
2 edit position, click cube, set to 4 at top, end edit
3 edit position again, click cube, set to 1 (64) in middle, end edit
All ok. The set cube command worked too.
Jon