[Freeipmi-devel] Re: [llnl-devel] power control and BMC configuration problem

[Albert Chu]

Hmmm, perhaps this is related to the Suspend BMC ARPs Command (19.3)???

"This command can be used to suspend BMC-generated ARPS while run-time
software is handling them."

Al

--
Albert Chu
address@hidden
Lawrence Livermore National Laboratory

----- Original Message -----
From: Albert Chu <address@hidden>
Date: Tuesday, January 20, 2004 11:30 am
Subject: Re: [llnl-devel] power control and BMC configuration problem

> > Am I understanding this correctly? It doesn't happen if you just 
> pull 
> > the plug, only if you do a software halt?
> 
> Haven't tried pulling the plug, but so far we only see this on a
> software halt.
> 
> > Also, have you ever run our BMC configurator on the "test cluster"?
> 
> I've run it, but our test cluster was initially configured with the 
> SMUprogram.  So whatever SMU defaults were put in the BMC firmware are
> still there.
> 
> Al
> 
> --
> Albert Chu
> address@hidden
> Lawrence Livermore National Laboratory
> 
> ----- Original Message -----
> From: Ian Zimmerman <address@hidden>
> Date: Tuesday, January 20, 2004 11:18 am
> Subject: Re: [llnl-devel] power control and BMC configuration problem
> 
> > Albert Chu <address@hidden> writes:
> > 
> > > We are currently having a power control problem on thunder.  
> > After we
> > > halt a machine (/sbin/halt), the BMC is no longer reachable.  
> We 
> > haven't> this problem on our test cluster of tiger4s, only on 
> thunder.> 
> > Am I understanding this correctly?
> > It doesn't happen if you just pull the plug, only if you do a 
> > software halt?
> > 
> > Also, have you ever run our BMC configurator on the "test cluster"?
> > 
> > Ian
> > 
> 
> 
> _______________________________________________
> llnl-devel mailing list
> address@hidden
> http://californiadigital.com/cgi-bin/mailman/listinfo/llnl-devel
>