Re: [Freeipmi-users] FreeIPMI recognizes OEM sensor, but it does not return a reasonable state for it

[larsen007]

>> # /usr/local/sbin/ipmimonitoring
>> ID | Name             | Type                     | State    | Reading    | 
>> Units | Event
>> 74 | SD vFlash Status | Module/Board             | N/A      | N/A        | 
>> N/A   | 'OEM Event = 0000h'
>>
>>
>> Though, the state is still shown as "N/A".

> Since this is an OEM sensor, you need to specify --interpret-oem-data
> (you can config it in /etc/freeipmi/freeipmi.conf so its on by default
> in the future).


doesn´t look very different... Did I forget something else?

incubus:~# /usr/local/sbin/ipmimonitoring --interpret-oem-data 
--output-sensor-state
ID | Name             | Type                     | State    | Reading    | 
Units | Event
74 | SD vFlash Status | Module/Board             | N/A      | N/A        | N/A  
 | 'OK'


Lars