[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Gcl-devel] #n= syntax

From: Camm Maguire
Subject: [Gcl-devel] #n= syntax
Date: Wed, 23 Aug 2017 14:08:49 -0400

Greetings!  The ansi-spec describes n as an unsigned decimal, but all
lisp printers I have seen start n at 1.  Is there any problem starting it
at 0?

Take care,
Camm Maguire                                        address@hidden
"The earth is but one country, and mankind its citizens."  --  Baha'u'llah

reply via email to

[Prev in Thread] Current Thread [Next in Thread]