Re: [Gluster-devel] Boot stops at GNU GRAB

[Susumu Urata \(Technocross\)]

The email regarding the GRUB error was caused by some errors on the 
CD.  I burned a new CD and then loaded the client.  It was 
successful except for the following errors.

I notices two errors at the beginning of loading the client node 
from the master.
Errors are:

gutils.gex      cant read
fs-utils.gex    cant read

I checked the MD5 value and it is the same as the one listed in the 
web.
I can open the file from the console.


Thanks
Susumu Urata
Technical Consultant

408-873-2760 (Voice)
408-873-2761 (Fax)
----- Original Message ----- 
From: "Anand Babu" <address@hidden>
To: "Susumu Urata (Technocross)" <address@hidden>
Cc: <address@hidden>
Sent: Monday, June 26, 2006 11:13 AM
Subject: Re: [Gluster-devel] Boot stops at GNU GRAB


> On Mon, Jun 26, 2006 at 09:25:36AM -0700, Susumu Urata 
> (Technocross) wrote:
> ,----
> | Using Gluster HPC, I have created a client node for the master 
> node
> | with FC5.  Except one error encountered before loading 
> Application,
> | everything looked like went OK.  The I rebooted the client, it 
> stops
> | at GNU GRUB.
> |
> | I expected the Linux (copy of FC5) starting up normally.
> |
> | Was the cause of this being client initialization failed?
> | What should I expect here as a normal behavior?
> | How should I start the Linux from here?
> `----
>
> I need more information. After installation of GlusterHPC, you 
> just
> reboot all the nodes and your cluster should be ready for running
> Scientific Applications.
>
> Something went wrong during the installation.
>
> 1) You mentioned except one error.. What error was that? Can you 
> give
> me more details?
See above

> 2) Grub loads and shows menu? or Grub itself doesn't load?
>
> Also, You should not use SELinux, LVM or software RAID (md).
>
> Disable SELinux by changing the following in 
> /etc/sysconfig/selinux
> and rebooting the system.
> SELINUX=disabled
>
> LVM/SW-RAID, use manual partitioning during installation of head 
> node.
>
> After you prepare such a head node, then boot it with gluster and
> install the cluster.
>
> Next RC3 release will have support for SELinux and LVM.
>
> --
> Anand Babu
> GPG Key ID: 0x62E15A31
> Blog [http://ab.freeshell.org]
> The GNU Operating System [http://www.gnu.org]