[Gluster-devel] Question on Geo-Replication

[Pitichai Pitimaneeyakul]

Hi there,

I ran into problem of synchronization in geo-replication is not completed.
And I found the the document say about force to full sync by erasing index and restart geo-replication
as below from Gluster Document. Somehow I went to Tuning Volume Options, there is nothing mention about erasing index.
Or it is just to set geo-replication.index=off and restart geo-replication ?

======

Synchronization is not complete

Description: GlusterFS Geo-replication did not synchronize the data completely but still the geo-replication status display OK.

Solution: You can enforce a full sync of the data by erasing the index and restarting GlusterFS Geo-replication. After restarting, GlusterFS Geo-replication begins synchronizing all the data, that is, all files will be compared with by means of being checksummed, which can be a lengthy /resource high utilization operation, mainly on large data sets (however, actual data loss will not occur). If the error situation persists, contact Gluster Support.

For more information about erasing index, see Tuning Volume Options.

======

Thank you and Best Regards,
Pitichai