Re: [Gluster-devel] [Gluster-users] Peers rejected, broken setup

[Nux!]

On 25.09.2013 18:24, Vijay Bellur wrote:
> On 09/25/2013 08:50 PM, Nux! wrote:
> > On 25.09.2013 15:42, Nux! wrote:
> > > Hello,
> > >
> > > I'm currently using 4 servers with various types of volumes on them,
> > > today I noticed 2 of them report the other 2 as "peer rejected" and
> > > viceversa.
> > > Where do I even begin to debug this? I don't see anything meaningful
> > > in the logs.
> > > Any pointers?
>
> "Peer rejected" is seen if there is a volume configuration mismatch
> between peers. Can you check if there is a mismatch in volume
> configuration between the two sets of peers?

I have checked the volumes "info" files following Krishnan's advice and 
they seem to have the same data, though oddly not exactly in the same 
place, e.g. some have auth.allow above rpc.auth-allow and it's 
counterpart info files from other servers have it the other way around, 
but the values are identical. Aren't these files supposed to be 100% the 
same?

Other than this, the volume files on all servers have port=0 for the 
bricks that are on the "rejected" peers.

So it's hard to say which is the "right" set of servers and on which I 
should execute the instructions from 
http://www.gluster.org/community/documentation/index.php/Resolving_Peer_Rejected

I'm afraid not to make this even a bigger disaster.

Suggestions?

--
Sent from the Delta quadrant using Borg technology!

Nux!
www.nux.ro