[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[gNewSense-users] eepro100 does not 'attach' to eth0

From: Keith Meyer
Subject: [gNewSense-users] eepro100 does not 'attach' to eth0
Date: Mon, 12 Feb 2007 11:51:21 -0500

Hey Everyone,
I've tried various "hacks" and "work arounds" for this problem.  I have a Dell Inspiron 2200 and I just installed gNewSense 1.1.  When it boots it won't load the eepro100 module that is needed for the Intel built-in ethernet.  No biggie so I just run `modprobe eepro100` however running `ifconfig` will show only the loopback. After that I tried running `ifconfig eth0 up` still no dice, it gives an error that is along the lines of it's not a real device.
Any ideas where to go from here?

reply via email to

[Prev in Thread] Current Thread [Next in Thread]