[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [gNewSense-users] Re: gNewSense-users Digest, Vol 40, Issue 30

From: Peter Rock
Subject: Re: [gNewSense-users] Re: gNewSense-users Digest, Vol 40, Issue 30
Date: Wed, 27 Jan 2010 11:33:42 +0800

Here's exactly what happens:

PMON> load (usb0,0)/vmlinux-
Loading file: (usb0,0)/vmlinux-
0x80200000/3555840 + 0x80564200/286128(z) + 6815 syms\
Entry address is 802063c0

PMON> initrd(usb0,0)/initrd.gz
Loading initrd image (usb0,0)/initrd.gz(bin)     #This process takes a
few minutes with a twirling backslash/frontslash on the right side of
the screen and then...

Loaded 5259509 bytes
PMON> g console=tty no_auto_cmd root=/dev/hda1 rootdelay=8 machtype=8.9

And here I get a lot of output I can't repeat along with a Tux the
penguin logo and eventually I'm taken to the first step of the
installation process (Choose language) instead of the installed gNS on
my system. According to dir (wd0,0)/ I have a system installed as it
lists all the typical directories starting with lost+found, var,
etc... all the way through to opt.

On Wed, Jan 27, 2010 at 10:52 AM, Quiliro Ordóñez <address@hidden> wrote:
>>>> I tried "load (usb0,0)/vmlinux-" and that seemed to be fine.
>>>> Then "initrd (usb0,0)/initrd.gz" and that didn't give me an error but
>>>> I don't know if this is what I'm to do
>>> I am very very sorry. the initrd line should read:
>>> initrd (wd0,0)/initrd.gz
>> Wait a minute..... The previous one was correct!
> initrd (usb0,0)/initrd.gz
> is correct!

reply via email to

[Prev in Thread] Current Thread [Next in Thread]