Nokia 6340 - TDMA - Telephone Interface Init Failed

[Adrian Abraham]

I've got a Nokia 6340 running in TDMA mode over the I/R port. Since it's 
AT compatible, I can just run minicom on /dev/ircomm0 and dial out. 
However, Gnokii isn't happy. I've tried setting model to AT, AT-HW, 6510, 
and 6340, and setting connection to both serial and irda. With the AT 
configuration, I get this:

Initializing AT capable mobile phone ...
Serial device: opening device /dev/ircomm0
Serial device: setting RTS to high and DTR to high
Message sent: 0x00 / 0x0004
41 54 5a 0d                                     | ATZ             
write: [ATZ<cr>]
read : [ATZ<cr><cr><lf>OK<cr><lf>]
Message received: 0x00 / 0x000a
02 41 54 5a 0d 0d 0a 4f 4b 0d                   |  ATZ   OK       
Received message type 00
Message sent: 0x00 / 0x0005
41 54 45 31 0d                                  | ATE1            
write: [ATE1<cr>]
read : [ATE1<cr><cr><lf>OK<cr><lf>]
Message received: 0x00 / 0x000b
02 41 54 45 31 0d 0d 0a 4f 4b 0d                |  ATE1   OK      
Received message type 00
Message sent: 0x4f / 0x0009
41 54 2b 43 53 43 53 3f 0d                      | AT+CSCS?        
write: [AT+CSCS?<cr>]
read : [AT+CSCS?<cr><cr><lf>ERROR<cr><lf>]
Message received: 0x4f / 0x0012
03 41 54 2b 43 53 43 53 3f 0d 0d 0a 45 52 52 4f |  AT+CSCS?   ERRO
52 0d                                           | R               
Received message type 4f
Message sent: 0x06 / 0x0008
41 54 2b 43 47 4d 4d 0d                         | AT+CGMM         
write: [AT+CGMM<cr>]
read : [AT+CGMM<cr><cr><lf>ERROR<cr><lf>]
Message received: 0x06 / 0x0011
03 41 54 2b 43 47 4d 4d 0d 0d 0a 45 52 52 4f 52 |  AT+CGMM   ERROR
0d                                              |                 
Received message type 06
Telephone interface init failed! Quitting.
Serial device: closing device


If model is set to 6510, it just spews over and over
unknown: Nokia 6340     7ef6

With it set to 6340, it says
Sorry, phone has not yet been converted to new style. Phone.Functions == 
NULL!
(And, yes, I'm using 0.4.3)

With the AT models, enabling the DCD check causes the programs to fail 
instantly. With the numbered models, the program still freezes.

-- 
                                        
                        -Adrian Mark Abraham (address@hidden)
                        -CS1321 TA