nokia 3220

[massimo citterio]

hi
I'm using a clone DKU5 (from ebay ) in order to connect to nokia 3220 
but I cannot !
so I think that my cable is not a pl2303 one. 
How can I check which chip is it using?
Is there any other module supported ?

these are some debug info

modules:
 modprobe usbserial vendor=0x0e55 product=0x110b
 modprobe  pl2303

GNOKII Version 0.6.8

dmesg:
usb 1-1: new full speed USB device using uhci_hcd and address 4
usbserial_generic 1-1:1.0: Generic converter detected
usb 1-1: Generic converter now attached to ttyUSB0


usbview says:

usbserial_generic
Speed: 12Mb/s (full)
USB Version:  1.10
Device Class: ff(vend.)
Device Subclass: 01
Device Protocol: 00
Maximum Default Endpoint Size: 8
Number of Configurations: 1
Vendor Id: 0e55
Product Id: 110b
Revision Number:  0.08

Config Number: 1
        Number of Interfaces: 1
        Attributes: 80
        MaxPower Needed: 440mA

        Interface Number: 0
                Name: usbserial_generic
                Alternate Number: 0
                Class: 00(>ifc ) 
                Sub Class: 0
                Protocol: 0
                Number of Endpoints: 3

                        Endpoint Address: 81
                        Direction: in
                        Attribute: 3
                        Type: Int.
                        Max Packet Size: 10
                        Interval: 1ms

                        Endpoint Address: 02
                        Direction: out
                        Attribute: 2
                        Type: Bulk
                        Max Packet Size: 64
                        Interval: 0ms

                        Endpoint Address: 83
                        Direction: in
                        Attribute: 2
                        Type: Bulk
                        Max Packet Size: 64
                        Interval: 0ms

 gnokii --identify 
GNOKII Version 0.6.8
LOG: debug mask is 0x1
LOG: rlpdebug mask is 0x1
phone instance config:
model: 6510
port_device: /dev/ttyUSB0
connection_type: 0
init_length: 0
serial_baudrate: 19200
serial_write_usleep: -1
hardware_handshake: 0
require_dcd: 0
smsc_timeout: 100
connect_script:
disconnect_script:
rfcomm_cn: 1
sm_retry: off
Connecting
Serial device: opening device /dev/ttyUSB0
Serial device: setting speed to 115200
Serial device: setting RTS to low and DTR to low
Getting model...
Message sent: 0x1b / 0x0006
00 01 00 07 01 00                               |
Serial write: transmitter busy, waiting
Serial write: transmitter ready
SM_Block: exiting the retry loop
Message sent: 0x1b / 0x0006
00 01 00 07 01 00                               |
SM_Block: exiting the retry loop
Message sent: 0x1b / 0x0006
00 01 00 07 01 00                               |
SM_Block: exiting the retry loop
Serial device: opening device /dev/ttyUSB0
Serial device: setting speed to 115200
Serial device: setting RTS to low and DTR to high
Getting model...
Message sent: 0x1b / 0x0006
00 01 00 07 01 00                               |
Serial write: transmitter busy, waiting
Serial write: transmitter ready