RE: gnokii make error in FC7 [SEC=UNCLASSIFIED]

[Wong, Cheung]

Thanks Kot,

I had to use yum install gnokii in FC7, and it installed an older
version I think 0.6.14 and it's working fine now, however I couldn't get
it to work with 0.6.19 from binary.

but it's working perfectly for me. now I just have to incorporate the
command line in to nagios!

Thanks very much
Cheung

-----Original Message-----
From: address@hidden
[mailto:address@hidden On Behalf Of
Pawel Kot
Sent: Friday, 19 October 2007 5:04 PM
To: Discussion forum for gnokii users.
Subject: Re: gnokii make error in FC7 [SEC=UNCLASSIFIED]

Hi,

On 10/19/07, Wong, Cheung <address@hidden> wrote:
> I tried to intall Gnokii, but received the below error, please advice
> gmake[1]: Entering directory `/usr/local/nagios/gnokii-0.6.19/po'
> gmake[1]: *** No rule to make target `POTFILES.in', needed by
`Makefile'.  Stop.
> gmake[1]: Leaving directory `/usr/local/nagios/gnokii-0.6.19/po'
> gmake: *** [po] Error 2

Is it official gnokii tarball? Did you run configure script? Please give
details on your setup.

pkot
--
Pawel Kot


_______________________________________________
gnokii-users mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/gnokii-users
 

##################### Important Notice ###################### 
This e-mail and attachments (if any) is intended for the original 
addressee only.  If you are not the intended recipient , any use 
or dissemination of this communication is prohibited.  
Please advise the sender by return e-mail and delete the e-mail