ubxtool port?

[John Ackermann N8UR]

I am getting my ZED-F9T set up to do the comparison between GPS only and
GPS+GLONASS for NRCan processing.

The only eval board available for the F9T is the one from uBlox, and it
sucks.  The only connectivity on the board is a single 10-pin header
with UART TXD and RXD.  (And, just for fun, the antenna connector is an
SMB!).

I have a UART to USB converter wired up and can talk to the unit.

My question is, will ubxtool tell the F9T to enable messages, etc., on
the UART port, or does it only configure the USB interface (which of
course isn't accessible on this board)?

Thanks,
John