Stall due to babble when reading card ATR from CCID device using UHCI

[Lenthamre Johan]

Hi,

When reading card ATR from a CCID device (RDR_to_PC_DataBlock), the bulk-in 
endpoint is stalled due to babble. I still get the complete ATR though. I've 
successfully issued other commands, such as PC_to_RDR_GetSlotStatus and read 
back the result ok. The reader is a 2.0 device plugged into a 1.1 controller 
using GRUB's UHCI driver. The TD status is 0x18500009; stall + babble. I am not 
really sure where to go from here or where to start looking. Any hints are 
appreciated.

Clear halt doesn't solve the issue.

BR

/Johan

---------------------------------------
Johan Lenthamre
Software Engineer
Command and Control Systems Division
Security and Defence Solutions
Telephone: +46 8 5808 4818
Mobile: +46 73 437 4818
address@hidden 
Saab
Nettovägen 6
SE-175 88 Järfälla
www.saabgroup.com 
---------------------------------------
This e-mail is private and confidential between the sender and the addressee. 
In the event of misdirection, the recipient is prohibited from using, copying 
or disseminating it or any information in it. Please notify the above of any 
such misdirection.