[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Help-gnucap] model for PIN diode in gnucap
From: |
vsrk sarma |
Subject: |
[Help-gnucap] model for PIN diode in gnucap |
Date: |
Wed, 6 May 2009 17:14:20 +0530 |
Hi,
I am just starting to use gnucap for circuit simulation.
Can diode model generated in gnucap b e used for PIN diodes?
I need to find a equivalent an obsolete & unavailable silicon pin
diode used in protection/attenuation front end of amplifier.
Target diode manufacturer provides following spice model
parameters: Is, Rs, N, Cjo, Cp, M, EG, Vj, BV, IBV. (In gnucap
Cp, BV, IBV are not used). Are these sufficient to simulate
protection/attenuation behavior with pulsed VHF input?
Do the simulation take care of resistance & capacitance variation due to
space charge accumulation in i layer?
--
vsrk sarma
[Prev in Thread] |
Current Thread |
[Next in Thread] |
- [Help-gnucap] model for PIN diode in gnucap,
vsrk sarma <=