Re: trouble booting hurd

[Michal Medvecký]

> Well, without some more details, it is very difficult to give you some
> more help.

OK. I have 40gb ide barracuda on ata-66.


Disk /dev/hda: 255 heads, 63 sectors, 4865 cylinders
Units = cylinders of 16065 * 512 bytes

   Device Boot    Start       End    Blocks   Id  System
/dev/hda1   *         1       124    995998+  83  Linux
/dev/hda2          1025      4865  30852832+   5  Extended
/dev/hda3           125      1024   7229250   83  Linux
/dev/hda5          1025      1090    530113+  83  Linux
/dev/hda6          1091      1613   4200966   63  GNU HURD or SysV
/dev/hda7          1614      4865  26121658+  83  Linux

Partition table entries are not in disk order


dmesg:

ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: IDE controller on PCI bus 00 dev 39
VP_IDE: chipset revision 16
VP_IDE: not 100% native mode: will probe irqs later
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: VIA vt82c686a (rev 21) IDE UDMA66 controller on pci00:07.1
    ide0: BM-DMA at 0xd000-0xd007, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0xd008-0xd00f, BIOS settings: hdc:pio, hdd:pio
hda: ST340016A, ATA DISK drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: 78165360 sectors (40021 MB) w/2048KiB Cache, CHS=4865/255/63, UDMA(33)


what else do you need?