help-make
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Is it possible to break from a GMAKE foreach loop and then exit from


From: Pierre Rouleau
Subject: Re: Is it possible to break from a GMAKE foreach loop and then exit from make?
Date: Mon, 30 May 2022 15:04:09 -0400

On Mon, May 30, 2022 at 1:52 PM Paul Smith <psmith@gnu.org> wrote:

>
> It may not be worth worrying about until you actually start to run into
> problems.  Premature optimization is the cause of a lot off issues in
> programming, and also build systems :).
>

That's for sure!

-- 
/Pierre


reply via email to

[Prev in Thread] Current Thread [Next in Thread]