[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Problem running code segment with F9
From: |
sidewinder77 |
Subject: |
Problem running code segment with F9 |
Date: |
Tue, 23 Feb 2010 06:01:51 -0800 (PST) |
Hi,
Just started using Octave and am getting on ok however I seem to be running
into a strange problem, not sure if this is a bug. I have some fairly
standard (I think) code. From my days with Matlab I am used to being able
to highlight sections of the code and run just that section using F9.
This works if I select a single line of code, however if I select more than
one line, I get the error
error: invalid character `â' (ASCII 226) near line 217, column 44
parse error:
>>> clear allâ©â©load ground11.datâ©x = 64;â©y = 8;â©z = 8;
This error was generated when I tried to F9 the following selection
clear all
load ground11.dat
x = 64;
y = 8;
z = 8;
Any ideas what I am doing wrong? Thanks in advance.
Joe
[edit]Just thought I should mention I am running qtOctave on Arch
linux[/edit]
--
View this message in context:
http://old.nabble.com/Problem-running-code-segment-with-F9-tp27703622p27703622.html
Sent from the Octave - General mailing list archive at Nabble.com.
[Prev in Thread] |
Current Thread |
[Next in Thread] |
- Problem running code segment with F9,
sidewinder77 <=