Re: [Linphone-users] Setting up linphone with IPV6

[Mikael Magnusson]

On 01/07/2013 12:17 PM, Nicky Borg wrote:

Hi Can someone guide me how to REGISTER to an IPV6 enabled pbx? 

in the Configure a sip account section, how should I configure that part? 

The only guide I could find is this

http://blogs.voxeo.com/speakingofstandards/2011/04/08/how-to-make-sip-calls-over-ipv6-using-linphone-on-mac-windows-linux/

But this describes how to make a call without registration. I am still not able to get past that part.

I don't think there are any special settings except the setting which switches between ipv4 and ipv6.

I use the following configuration:

Your SIP identity: sip:address@hidden
SIP Proxy address: sip:sip.server.domain
Route: sip:sip.server.domain;lr

I you want to use the above config, then you should change "server.domain" to the domain of the SIP account, and sip.server.domain to the name of the server.

/Mikael

There is no NAT involved in my test. Thanks

--

Regards

--

Nick Borg
3CX - Developers of IP PBX software
http://www.3cx.com

3CX News, Tips and How to's at http://www.3cx.com/blog/
Help / Wiki pages at http://www.3cx.com/blog/help/

Get notified about new blog posts and help articles:
Via email: http://feedburner.google.com/fb/a/mailverify?uri=3CXVoIPBlog
Via RSS: http://feeds.feedburner.com/3CXVoIPBlog

_______________________________________________
Linphone-users mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/linphone-users