Hi, Newbie here, long time user of Obihai ATAs, used to doing my own setup.
Here's a problem I can't seem to solve:
I set up a Service Provider and Voice Service for a new Linphone account on an Obi 200. It registers fine and I can initiate SIP calls to Voip.ms, callcentric, and SIPBroker.
I can't call it, though. I get 403 and 404 errors from voip.ms
, callcentric, and 2 different ways from SIPBroker: a) using the **275 route from callcentric, and b) dialing from a PSTN line (in both cases using the *8954 proxy code for linphone).
When dialing from an Obi 202, I put the URI in a speed dial slot.
So, am I an idiot and missing something obvious, or is something subtle going on?
Thanks in advance.