[Nmh-commits] nmh INSTALL [nmh-1_3-branch]

[David Levine]

CVSROOT:        /sources/nmh
Module name:    nmh
Branch:         nmh-1_3-branch
Changes by:     David Levine <levine>   08/05/21 16:56:48

Modified files:
        .              : INSTALL 

Log message:
        * configure.in, INSTALL: if --enable-masquerade is not
        specified to configure, enable all supported masquerade forms.
        This allows users to masquerade with the default
        configuration.  That seems to be more worthwhile now than
        trying to prevent users from using it, especially with
        single-user installations or those where a user can edit
        etc/mts.conf.  (Ported from trunk.)

CVSWeb URLs:
http://cvs.savannah.gnu.org/viewcvs/nmh/INSTALL?cvsroot=nmh&only_with_tag=nmh-1_3-branch&r1=1.15&r2=1.15.2.1

Patches:
Index: INSTALL
===================================================================
RCS file: /sources/nmh/nmh/INSTALL,v
retrieving revision 1.15
retrieving revision 1.15.2.1
diff -u -b -r1.15 -r1.15.2.1
--- INSTALL     24 Dec 2005 17:17:38 -0000      1.15
+++ INSTALL     21 May 2008 16:56:47 -0000      1.15.2.1
@@ -1,7 +1,7 @@
 #
 # INSTALL -- installation instructions
 #
-# $Id: INSTALL,v 1.15 2005/12/24 17:17:38 pm215 Exp $
+# $Id: INSTALL,v 1.15.2.1 2008/05/21 16:56:47 levine Exp $
 #
 
 --------------
@@ -171,14 +171,15 @@
      Enable debugging support.
 
 --enable-masquerade[='draft_from mmailid username_extension']    
-     If this option is not specified, the mts.conf file will contain the line
-     "masquerade: " (with no value), which may be manually edited later.  You
-     may find it convenient to specify a value at configure-time, however, so
-     that each time nmh is reinstalled, the right value will be there.
-
-     The above usage shows all three masquerade options being specified, but 
any
-     subset of the three may be specified.  If you do want to enable all three,
-     you can simply use `configure --enable-masquerade' as a shortcut.
+     If this option is disabled, the mts.conf file will contain the
+     line "masquerade: " (with no value), which may be manually edited
+     later.  You may find it convenient to specify a value at
+     configure-time, however, so that each time nmh is reinstalled,
+     the right value will be there.  By default, it is enabled.
+
+     The above usage shows the default, with all three masquerade
+     options being specified.  Any subset of the three may be
+     specified.
 
      See the mh-tailor(5) man page for full documentation of "masquerade:".