[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: 3.6.0 release
From: |
Jarno Rajahalme |
Subject: |
Re: 3.6.0 release |
Date: |
Fri, 25 Nov 2011 15:07:37 +0200 |
On Nov 25, 2011, at 13:49 , ext Joaquim Luis wrote:
>
> Than the honest thing to do is to assume that and put clearly on the Octave
> page that Windows is not supported.
>
That would mean the Octave does not even compile on Windows. That would be
going too far. Maybe the Octave page should just state that binary packages (on
all platforms) are to be found elsewhere (links provided, but no promise that
newest release is to be found there).
Having said that, I think that having binary packages for OSX and Windows is
very important for Octave. I came on board with 3.2 on Windows and used the it
to do my matlab assignments on my Ph.D. studies, while everyone else was using
matlab...
Jarno
- 3.6.0 release, John W. Eaton, 2011/11/22
- Re: 3.6.0 release, Jordi GutiƩrrez Hermoso, 2011/11/22
- Re: 3.6.0 release, John W. Eaton, 2011/11/24
- Re: 3.6.0 release, Joaquim Luis, 2011/11/24
- Re: 3.6.0 release, John W. Eaton, 2011/11/25
- Re: 3.6.0 release, Joaquim Luis, 2011/11/25
- Re: 3.6.0 release,
Jarno Rajahalme <=
- Re: 3.6.0 release, Lukas Reichlin, 2011/11/25
- Re: 3.6.0 release, Ben Abbott, 2011/11/25
- Re: 3.6.0 release, J. Luis, 2011/11/26
- Re: Bus error with Octave built with Homebrew/MacOSX, Ben Abbott, 2011/11/26
- Re: Bus error with Octave built with Homebrew/MacOSX, J. Luis, 2011/11/26
- Re: Bus error with Octave built with Homebrew/MacOSX, Ben Abbott, 2011/11/26
- Re: 3.6.0 release, Alexander Hansen, 2011/11/24
- Re: 3.6.0 release, John W. Eaton, 2011/11/25
- Re: 3.6.0 release, Jordi GutiƩrrez Hermoso, 2011/11/24
- Re: 3.6.0 release, John W. Eaton, 2011/11/25