|
On Jan 13, 2012, at 12:11 AM, Robinson, Melvin D wrote:
On Jan 12, 2012, at 10:26 PM, Robinson, Melvin D wrote:
On Jan 12, 2012, at 10:16 PM, Robinson, Melvin D wrote:
On 1/12/12 8:52 PM, "Ben Abbott" <address@hidden> wrote:
On Jan 12, 2012, at 9:40 PM, Robinson, Melvin D wrote:
On 1/12/12 8:35 PM, "Ben Abbott" <address@hidden> wrote:
On Jan 12, 2012, at 9:16 PM, Robinson, Melvin D wrote:
I'm having some problems with make check on Lion. Fedora worked fine.
Can you tell me about Lukas' modified port file? I missed that email.
Melvin
The modified portfile for rc1 is attached.
Make sure you have qhull_2010.3 installed.
sudo port activate qhull @2010.1_3
Ben
I have 2011.2 installed. On Macports:
butterfly:octave-3.6.0-rc1 melrobin$ port list qhull
qhull @2011.2 math/qhull
It appears that only @2010.1_3 is unavailable. Can you tell me what I I
can do to install that version?
Please respond below so that those who arrive late can follow along.
If you tried to activate "qhull @2010_3" and that failed, then you can
install the older version by ...
sudo port install qhull @2010.1_3
Ben
Is there something crazy about my system? I uninstalled 2011.2 and used
sudo port install qhull @2010.1_3 as you said and it reinstalled hull
2011.2_1.
What does "port installed | grep qhull" return for you ?
I get ....
port installed | grep qhull
qhull @2010.1_3 (active)
qhull @2011.1_0
qhull @2011.1_1
qhull @2011.2_1
Ben
Something has gone amiss for me:
butterfly:~ melrobin$ port installed | grep qhull
qhull @2011.2_1 (active)
Ok. What is the result of ...
sudo port install qhull @2010.1_3
Ben
butterfly:~ melrobin$ sudo port install qhull @2010.1_3
---> Cleaning qhull
It seems that no action was taken. I never installed qhull @2010.1_3 so maybe that's the problem.
$ sudo port selfupdate
Maybe that helps?
Jarno
Thanks! I'm trying that and it is building gcc47 which should take a looooooong time.
You'll want to avoid gcc46 and gcc47. These gcc versions don't support "-arch=x86_64" ... Unless macports is doing something to patch Octave's sources ?
I recommend you use the gcc45 and fltk variants. The port command should be something like ...
sudo install octave36 @3.6.0-rc1_0 +atlas+fltk+gcc45
If you are able to build Octave using gcc47, please let me know. So far gcc46 has not worked for me.
Ben
I have gotten Octave to build a few times using gcc46…just the make checks (crashes on eigs and fails all convhulln.m) don't produce the best results. I'll try with gcc45 and variants and then with gcc47. I did have to use your sed commands to get it
to work with gcc46.
|