Re: @example's as doctests

[Colin Macdonald]

On 28/03/15 16:07, Oliver Heimlich wrote:
> Thus, only support for @group blocks in doctest is missing. doctest
> could use @end group as a separator between expected output and the next
> commands. However, this would be a little bit of a hack, because @group
> could also be used within expected output if it is very long. Any better
> ideas?

I see, I had not thought of that.

Maybe need to implement stepping through the code, checking one command 
at time.  This should be straightforward but will take me some time... 
And I'm not hugely motivated as I personally prefer ">>" to mark each 
command.

Alternatively (or perhaps additionally), any thoughts about adding a 
@prompt{} command?

Colin