[paparazzi-builds] [paparazzi] Build failed : master #1249

[Semaphore]

Build 1249 Failed For project paparazzi on branch master

View on Semaphore

Last commit for this build

	Christophe De Wagter	2 Nov 12:31
9531351 — [emergency-kill] Kill is a setting. To be less xml dependent it should be a message so that several boards can be killed together (#1872)

Build Results

52:17

Thread #1

ls -lah $SEMAPHORE_CACHE_DIR

00:00

df -h

00:00

docker pull flixr/pprz-dev

01:28

df -h

00:00

sudo rm -rf /home/runner/{.phpbrew,.phpunit,.kerl,.kiex,.lein,.nvm,.npm,.rbenv}

00:12

df -h

00:00

git --version

00:00

git status --ignored

00:00

git submodule deinit --force .

00:00

rm -rf .git/modules

00:00

git submodule update --init --force --recursive

00:36

if [ "$SEMAPHORE_TRIGGER_SOURCE" = "scheduler" ]; then docker/run.sh -it flixr/pprz-dev make test_all_confs ; else docker/run.sh -it flixr/pprz-dev make test ; fi

49:12

( Showing only the last 30 out of 102 lines. For a complete log visit the build page )

        No SRTM data found to check altitude.

Warning: Waypoint 'dummy' too far from HOME (59>20)


subsystems/ahrs/ahrs_int_cmpl_quat.c:47:2: warning: #warning "Using both magnetometer and GPS course to update heading. Probably better to configure USE_MAGNETOMETER=0 if you want to use GPS course." [-Wcpp]
 #warning "Using both magnetometer and GPS course to update heading. Probably better to configure USE_MAGNETOMETER=0 if you want to use GPS course."
  ^


# compiling AIRCRAFT: [MavTecLS] TARGET: [ap]

Warning: AIRCRAFT=MavTecLS target=ap compiled sucessfully but had warnings:
firmwares/rotorcraft/guidance/guidance_v.c: In function 'guidance_v_run':
firmwares/rotorcraft/guidance/guidance_v.c:331:7: warning: switch missing default case [-Wswitch-default]
       switch(guidance_v_guided_mode)
       ^



tests/aircrafts/01_compile_all_aircrafts.t .. 7/9 # compiling AIRCRAFT: [MavTecLS] TARGET: [nps]

tests/aircrafts/01_compile_all_aircrafts.t .. 8/9 
                                                   
tests/aircrafts/01_compile_all_aircrafts.t .. ok
All tests successful.
Files=1, Tests=9, 38 wallclock secs ( 0.02 usr  0.01 sys + 80.62 cusr 20.31 csys = 100.96 CPU)
Result: PASS
failed conf/airframes/TUDELFT/tudelft_conf.xml
failed conf/airframes/OPENUAS/openuas_conf.xml
failed conf/airframes/OPENUAS/openuas_obc2014_conf.xml
Makefile:316: recipe for target 'test_all_confs' failed
make: *** [test_all_confs] Error 1

      

df -h

00:00

Manage your email notification settings.

Is this email not displaying correctly? Report the issue.

Sent by Semaphore