Group,
I am about halfway through my learning curve from Protel 99SE/DXP to
Eagle. I am observing some unexpected operation in the schematic
editor. When I pan around the schematic it appears that up to half of
my design is outside of an invisible boundary and cannot pan to see
them unless I zom out fully and zoom "down" on the components I am
targeting. I am using the Windows port and have not yet tried it in
the Linux version. Do I need to define a document size or otherwise
define this boundary so the schematic editor is "ok" with the size of
my schematic.
Thanks,
Matthew Currie (dc3aes)
|