Hi there
Sometimes this happened
to me as well, even though I am not using TWOG, one way I found it work is by
disconnect the power and reconnect it again, try it, see if it works
Regards
Chen
From:
address@hidden
[mailto:address@hidden On Behalf Of Mohit Mundhra
Sent: Tuesday, October 07, 2008
12:14 PM
To: address@hidden
Subject: [Paparazzi-devel] TWOG -
no answer on '?'
when I try to
upload the usb bootloader onto the TWOG board, it is giving me this message.
Even when I tried to upload the code using the ISP flash mode, it is giving 'no
answer on '?' ' message. Is the board working fine? What can be the probable
problem. This is a new TWOG board which I got from PPZUAV. I have checked the
3.3 and 5 V rail. The voltages are fine on them.
ioctl set ok, status = 6
ioctl get ok, status = 6
ioctl get ok, status = 6
ioctl set ok, status = 4
ioctl get ok, status = 4
ioctl get ok, status = 4
ioctl set ok, status = 0
ioctl get ok, status = 0
no answer on '?'
make: *** [upload_bl] Error 4
--
Mohit Mundhra
--~--~---------~--~----~------------~-------~--~----~
Aurora
Integrated Systems
-~----------~----~----~----~------~----~------~--~---