Re: [Paparazzi-devel] Servo jittering...

[Gareth Roberts]

Is your RX connected and working (according to GCS)?
Otherwise it might put itself in AUTO1/AUTO2, both of which result in a  
bit of jitter (especially on the ground).
Or outside interference? Try a single new servo - it could be a single  
dying servo in the xeno polluting the 5V supply.
--G


On Mon, 06 Dec 2010 17:43:44 -0000, Volodymyr Khudyakov  
<address@hidden> wrote:

> Hi gang...
> Today I looking for very strange issue.
> When I connect my TINY to all electronic components and switch ON,  
> servos in
> my Multiplex Xeno start jitter.
> So, I successive disconnect electronics - Xbee, TV, ESC. Nothing, any
> results - jittering.
> Finally, I connect only AP, Rx and servos. Rx and servos powered form
> separate battery. Nothing, any results - jittering.
> I change AP...
> Nothing, any results - jittering.
> Who know, where is problem? Suggestions for next step?
>
> Sincerely you
> Vladimir
>
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel