Hi,
thanks to all of you, that was the problem, I had only defined 6
channels, but there arrived 8 at the tiny.
After adding 2 unused channels it worked. The Telemetry_mode_fbw
works as well.
Best Regards
Tim
Am 2010-12-28 15:52, schrieb Felix Ruess:
Hi Tim,
you updated your airframe file to the subsystems?
You can still activate the ppm message just like before and like
it says on the wiki ( http://paparazzi.enac.fr/wiki/Radio_Control#Measuring_the_PPM_time_values
) by adding
<define name="TELEMETRY_MODE_FBW" value="1"/>
to the firmware section in your airframe file.
What changed and I guess is your problem is that now the ppm
signal is better checked for validity and the number of channels
has to match _exactly_ to be a valid signal.
Cheers, Felix
On Tue, Dec 28, 2010 at 3:34 PM, Tim
Hansen <address@hidden>
wrote:
Hi,
I had a working setup with an older version of paparazzi (svn
checkout 2009-07) after migration to a newer version (git
2010-11-28) the radio doesn't work anymore. The aircraft is in
auto2 all the time. I checked with an oscilloscope: The pulses
arrive at the tiny. So it must be an software problem.
I tried to activate the ppm messages but the information in
the wiki about this is outdated (old airframe config file).
Can someone tell me how they should be activated in the
current version, or what might be the reason for the not
working radio ?
I wish everybody a good start into next year
Tim
_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
|