Re: [Paparazzi-devel] Lisa M wiring layout

[Eduardo lavratti]

Bruzzlee, the correct way to powert lisa/m is the i2c1 as you say.
The vin in used to monitor the battery voltage.
In my setupi i use 7v to power the lisa/m because the onboard regulator work very HOT with 12v.
So i connect the vin directo to battery and a 7v to v_batt pin.

---

Date: Sun, 1 Jan 2012 14:43:06 +0100
From: address@hidden
To: address@hidden
Subject: Re: [Paparazzi-devel] Lisa M wiring layout

Thanks for the answers.

@ Eduardo
Of course I will share my tests to the community

@ Eric
Is the Lisa M usually been powered by the I2C1 CAN plug with 11.1V?
Because this looks strange to me...

Bruzzlee

Am 31.12.11 21:03, schrieb Eduardo lavratti:

Bruzzlee, i am using lisa/m too.
Please, report your tests to the group.

I have strange behavior with my copter.
Some of this caused by vibration and other that i not know the cause.

regards.

> From: address@hidden
> Date: Sun, 1 Jan 2012 01:46:19 +1030
> To: address@hidden
> Subject: Re: [Paparazzi-devel] Lisa M wiring layout
>
> Hi Bruzzlee
>
> It looks good to me and yes the ADC1 bridge is needed only for the initial bind to the Spektrum receiver (or receivers, you can use two at once)
>
> Eric
>
> On 30/12/2011, at 7:51 AM, Bruzzlee wrote:
>
> > Hi all
> > After a long break I've continued the work on my quadrotor Lisa M project. Now I've done my wiring layout but I'm not sure if everything is correct.
> > Especially the power source for the board: I2C1 CAN (V_BATT/GND) or SERVO1 (SV/GND)?
> > The ADC1 bridge - I need it only for the first binding to the spectrum remote - right?
> >
> > I want to publish this layout on wiki - please report mistakes!
> >
> > thx
> > Bruzzlee
> > <LisaMWiring.png>_______________________________________________
> > Paparazzi-devel mailing list
> > address@hidden
> > https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

_______________________________________________ Paparazzi-devel mailing list address@hidden https://lists.nongnu.org/mailman/listinfo/paparazzi-devel