Re: [Paparazzi-devel] Lisa M, servo 7 and 8

[Felix Ruess]

Hi Loic,

just add <define name="USE_SERVOS_7AND8"/> to your firmware section and make sure you don't use I2C1 at the same time.
I just added a small check for this to v3.9, so it will error if you try to use both at the same time.

Cheers, Felix

On Mon, Jun 18, 2012 at 11:14 AM, Loic Drumettaz <address@hidden> wrote:

Hello,

On a lisa M V2.0, i didn't manage to use servo 7 and 8. The wiki says that they are connected to I2C1: is there something to do (jumper configuration or software) to activate these servos?

Thanks
Loïc

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel