Hi Christoph,
Can you start the motors ? Can you send your airframe file (or use
pastebin or alike) so we can see the what is your exact
configuration. Thanks
Gautier
On 16/07/2012 23:23, Christoph Niemann wrote:
Dear Community,
some weeks ago, I wrote a mail about my problem, using the old
booz IMU with the HMC5843 or HMC5883L with the lpc based booz ap.
Investigating this further, I found that for me, using the pretty
current 3.9 branch (v3.9.2_testing-3-g38ebd01-dirty), the I2C for
LPC doesn't seem to work at all.
I tried both the hmc5843 and hmc5883l on the booz board. It didn't
work. Next I tried those boards using a TWOG, it did't work. I
suspected there is an issue with the hmc driver, so I tried an ETS
Baro, it didn't work either. So I tried the code from about a year
ago (95a65a7-dirty). The baro was working.
What could be the Problem? I used a logic anaylzer, to investigate
it further. in the working version, there was data going through
the bus. In the new version both lines where high.
Every help would be appreciated.
Best Regards
Christoph
_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
|