Re: [Paparazzi-devel] px4fmu

[Felix Ruess]

Hi Oswald,

quite some time ago I wrote a basic board file for the px4fmu_1.7, but I'm not sure if anyone ever used/tested it...

You should be able to flash it via stm32_mem or BMP (try SWD mode)

Let us know how it goes...

Cheers, Felix

On Wed, May 20, 2015 at 3:00 PM, Oswald Berthold <address@hidden> wrote:

Hector Garcia de Marina writes:

> Hi Oswald,
>
> I have never used ppz in px4. But I guess that the guys from px4 are not
> using the same bootloader as in ppz (i am not sure about this).
>
> In any case if you flash the chip via JTAG with the ppz firmware, you
> should be able to use the bootloader for the following flashes.

hi hector, thanks for the reply.

i have tried flashing with the BMP but i seem to have a problem
there. gdb says

Target Voltage: 0.8V
JTAG device scan failed.

the board is powered from USB which i think should be fine. need to
check what is going on there.

bst, oswald

> On May 20, 2015 12:48 PM, "Oswald Berthold" <address@hidden> wrote:
>
>>
>> dear all,
>>
>> i have a px4fmu v1.6 lying around, which i would like to use it with
>> ppz. i built the ap but i haven't managed to flash it yet. is there a
>> preferred method? is anybody using a px4 with ppz at all?
>>
>> bst, oswald
>>
>>
>> _______________________________________________
>> Paparazzi-devel mailing list
>> address@hidden
>> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel