Re: [Paparazzi-devel] paparazzi secure datalink compile errors.

[Chris]

Hi Michal

I tried both v1 and v2 but the outcome is the same it does not establish 
a link

Here is the output i constantly get minus the warnings:

    Finished release [optimized] target(s) in 0.03s
     Running `paparazzi/sw/ext/rustlink/target/release/rustlink --udp 
--udp_broadcast -a 8 -n secure_fixed_wing -c -v 2.0`
Value for ivy_bus: 127.255.255.255:2010
Value for ping_period: 1000
Value for status_period: 5000
Value for baudrate: 9600
Value for port: "/dev/ttyUSB0"
Use UDP: true
Use UDP broadcast: true
Value for remote_addr: 127.0.0.1
Value for pprzlink version: v2.0
Global message class is set to Telemetry
Sender id: ground_dl
Link name:
Value for aircraft name: Some("secure_fixed_wing")
Value for aircraft ID: 8
Enable GEC: true
Opening 
/home/hendrix/paparazzi/var/aircrafts/secure_fixed_wing/ap/generated/keys_gcs.h
Starting encrypted datalink...

Warning: 'modules' node is deprecated, please move modules to 'firmware' 
section

Warning: 'modules' node is deprecated, please move modules to 'firmware' 
section

Warning: 'modules' node is deprecated, please move modules to 'firmware' 
section

Warning: 'modules' node is deprecated, please move modules to 'firmware' 
section

Warning: 'modules' node is deprecated, please move modules to 'firmware' 
section

Warning: 'modules' node is deprecated, please move modules to 'firmware' 
section

Warning: 'modules' node is deprecated, please move modules to 'firmware' 
section

Warning: 'modules' node is deprecated, please move modules to 'firmware' 
section

Warning: 'modules' node is deprecated, please move modules to 'firmware' 
section

Warning: 'modules' node is deprecated, please move modules to 'firmware' 
section

Warning: 'modules' node is deprecated, please move modules to 'firmware' 
section

Warning: 'modules' node is deprecated, please move modules to 'firmware' 
section
returning msg1, waiting msg2
again returning msg1, waiting msg2


<<

Chris, to your question - the secure link is by default started with 
`/paparazzi/sw/ext/rustlink/link  --udp  -a 1 -n Minion_RP3 -c  -v 2.0` 
so Pprzlink v2.0
You can change it to 1.0 if needed.

Michal

>>