Re: [PATCH v3 1/1] hw/arm/aspeed:Add vpd data for Rainier machine

[Cédric Le Goater]

[ ... ]

> However, regarding Cédric's log above, a reboot is expected on the first
> boot of a fresh image when there's valid VPD available. For the first
> boot of a fresh image we configure the kernel with a minimal devicetree
> that allows us to read the VPD data. This determines the system we're
> actually on and configures an appropriate devicetree for subsequent
> boots. We then reboot to pick up the new devicetree.

Yes. Then, the behavior looks correct under QEMU :

  https://www.kaod.org/qemu/aspeed/rainier/rainer.log

Here are the services which still have with some issues :

* clear-once.service                loaded failed     failed          Clear one 
time boot overrides
* ncsi-linkspeed@eth0.service       loaded failed     failed          Set eth0 
gigabit link speed
* ncsi-linkspeed@eth1.service       loaded failed     failed          Set eth1 
gigabit link speed
* obmc-flash-bios-init.service      loaded failed     failed          Setup 
Host FW directories
* system-vpd.service                loaded failed     failed          System 
VPD Collection
* trace-enable.service              loaded failed     failed          Enable 
Linux trace events in the boot loader

C.