[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Qemu-devel] [PATCH v5 00/11] Support for N25Q256/512 and AT25128/256
From: |
marcin . krzeminski |
Subject: |
[Qemu-devel] [PATCH v5 00/11] Support for N25Q256/512 and AT25128/256 |
Date: |
Sun, 20 Mar 2016 19:28:02 +0100 |
From: Marcin Krzeminski <address@hidden>
V5: Changes after review
- Macrofication of registers values
- Numonyx is default value in switch for fast read family
V4:
- Fixed RNVCR command (needed bytes set to 2 instead of 1)
- Config registers are configured only for micron flash devices
- Move config registers initialization to reset_memory function
- Removed clearing reset_enable flag when chip was selcted by CS signal
V3:
- Checkpatch run on patches
- Renamed function
V2:
- Removed support for mx66u51235 and s25fl512s from this series
- Corrected/implemented dummy cycles
- rebased to master
Marcin Krzeminski (11):
block: m25p80: Removed unused variable
block: m25p80: RESET_ENABLE and RESET_MEMORY commands
block: m25p80: Widen flags variable
block: m25p80: Extend address mode
block: m25p80: 4byte address mode
block: m25p80: Add configuration registers
block: m25p80: Dummy cycles for N25Q256/512
block: m25p80: Fast read and 4bytes commands
block: m25p80: Implemented FSR register
block: m25p80: n25q256a/n25q512a models
block: m25p80: at25128a/at25256a models
hw/block/m25p80.c | 330 ++++++++++++++++++++++++++++++++++++++++++++++++++----
1 file changed, 311 insertions(+), 19 deletions(-)
--
2.5.0
- [Qemu-devel] [PATCH v5 00/11] Support for N25Q256/512 and AT25128/256,
marcin . krzeminski <=
- [Qemu-devel] [PATCH v5 02/11] block: m25p80: RESET_ENABLE and RESET_MEMORY commands, marcin . krzeminski, 2016/03/20
- [Qemu-devel] [PATCH v5 10/11] block: m25p80: n25q256a/n25q512a models, marcin . krzeminski, 2016/03/20
- [Qemu-devel] [PATCH v5 01/11] block: m25p80: Removed unused variable, marcin . krzeminski, 2016/03/20
- [Qemu-devel] [PATCH v5 09/11] block: m25p80: Implemented FSR register, marcin . krzeminski, 2016/03/20
- [Qemu-devel] [PATCH v5 11/11] block: m25p80: at25128a/at25256a models, marcin . krzeminski, 2016/03/20
- [Qemu-devel] [PATCH v5 06/11] block: m25p80: Add configuration registers, marcin . krzeminski, 2016/03/20
- [Qemu-devel] [PATCH v5 07/11] block: m25p80: Dummy cycles for N25Q256/512, marcin . krzeminski, 2016/03/20
- [Qemu-devel] [PATCH v5 04/11] block: m25p80: Extend address mode, marcin . krzeminski, 2016/03/20